PRODUCT
CASE
ABOUT
Consultation Hotline:+86 18668915181
Email:info@cnyoniklaser.com
Address:Dangjia Industrial Zone ,Shizhong District, Jinan City, Shandong Province, China
Online Service
-YouTube-
The burr problem needs to be analyzed from three aspects: materials, equipment and process:Burrs of metal materials:Insufficient gas purity: Nitrogen purity must be ≥99.9%, otherwise the oxidation reaction residue will adhere to the edge. It is recommende
View details 2025-04-11This alarm may involve power supply, cooling or hardware failure:Check the power supply system:Use a multimeter to measure whether the laser input voltage is stable (220V±5%) and the ground resistance is <4Ω.Check whether the power cord connector is oxidi
View details 2025-04-11Parameter settings must follow the "material-thickness-equipment" matching principle:Metal materials (taking stainless steel as an example):Power: For every 1mm increase in thickness, the power needs to be increased by about 200W (such as 1000W for 2mm an
View details 2025-04-11The failure to cut through the material is usually caused by the following reasons:Insufficient laser power: Check whether the laser power setting matches the material thickness. For example, cutting 8mm stainless steel requires at least 2000W power. If t
View details 2025-04-11Improper lens cleaning will scratch the coating. Please strictly follow the following steps:Disassembly and pre-cleaning:Turn off the device and wait for 10 minutes to prevent static electricity from attracting dust.Remove the lens with special tweezers a
View details 2025-04-11Sudden equipment shutdown requires multi-dimensional troubleshooting:Software and program failure:Check whether the control software is stuck (such as file path error or G code syntax problem), restart the software and reload the program.If the path gener
View details 2025-04-11Collision prevention requires a combination of hardware settings and process optimization:Precise follow-up height setting:Adjust the sensing range of the capacitive sensor according to the material thickness (for example, a 5mm plate needs to be set to a
View details 2025-04-11Water temperature alarm is usually caused by cooling system failure:Basic inspection:Confirm that the water level of the chiller water tank is ≥80%. If the liquid level is too low, add distilled water (tap water is prohibited to prevent scaling).Clean the
View details 2025-04-11